Page 1 of 1
Air Filter
Posted: March 26th, 2006, 5:01 pm
by Whitey
I curently have the stock intake on my mx and I need a new air filter. I was wondering if it would benifit me more to go out and get an OEM replacement or get a cone filter and attach it to my Mass Air. Im not sure because of the heat issues and such.
Posted: March 26th, 2006, 7:17 pm
by fieromx3
you do benefit by putting a cone filter on ur maf but u do benefit more by putting the filter where it gets cold air. IMO it helps more over the stock intake... as it did with my car
Posted: April 8th, 2006, 2:36 pm
by alex3ohio
do cone filter and then get an exhaust and you'll get some improvements. If your car is taking in more air but can't get it out fast enough it wont do you any good.
Posted: April 8th, 2006, 2:45 pm
by MXL (germany)
I'm using an cone air filter with an Honda Crx modified Intake.
For this you have to put the batterie (right in english?) in front of the gearbox. There is enough place for this.
So you do not have such an high angle, ant the air can flow easier into the Motor.
I hope you could understand me
Some pictures are available in the link in my signature
Posted: April 8th, 2006, 8:47 pm
by mx3autozam
I have a k&N oem replacment fro the 1.8L v6 for sale
.
Posted: April 9th, 2006, 5:29 am
by papadeez15
i put a cold air, but i dont have a full catback exhaust yet so i dont see a big diff...
but if u have all the set, ur high rpm ranges, are faster
Posted: April 14th, 2006, 5:46 pm
by alex3ohio
go to home depot and make one from PVC piping and rubber couplers. Easy and cheap