Custom Buddy club 2 Front end!

buddyclubmx3i · Post by **buddyclubmx3i** » December 14th, 2005, 2:53 pm

What you guys think....just an Idea I had.

Personally I think it's fire

2fazed · Post by **2fazed** » December 14th, 2005, 3:05 pm

It's nice. Hope the bumper becomes smaller, so you can drive on it.

MX-3 Money · Post by **MX-3 Money** » December 14th, 2005, 8:33 pm

Nice design, but its way to big. Wouldn't wanna drive that around, need a lift kit.

Legato626 · Post by **Legato626** » December 14th, 2005, 8:51 pm

thats the BC2 front i have that. Looks alot nicer with the holes on the sides. All you need to do is add some wire mesh in there like I did with some fog lights. =)

Hoodzy · Post by **Hoodzy** » December 15th, 2005, 10:38 am

i would remove those pieces along the side that make it look gayzor not the holes that make it look rad

Macen · Post by **Macen** » December 15th, 2005, 1:15 pm

Mr. Plow

Looks better with the holes on the sides. Don't like the round fog light holes, though.

Hoodzy · Post by **Hoodzy** » December 16th, 2005, 4:56 pm

extend the holes u got rid of inwards to remove the foglight holes and remove the side pieces and higher it so u can drive it and i'd say pretty fine dandy

customescortgt · Post by **customescortgt** » December 17th, 2005, 12:50 pm

me likes alot!

projectmx · Post by **projectmx** » December 17th, 2005, 4:25 pm

how much do you have the car lowered? my bc2 front had plenty of clearance.. i like taking those holes out... looks kinda cool

kimlin85 · Post by **kimlin85** » December 17th, 2005, 6:43 pm

i think it looks nice w/out the foglight holes.

AndysAutoSport · Post by **AndysAutoSport** » December 21st, 2005, 1:43 pm

The car looks great, maybe raise it just a notch and you should be good to go.

So you manufactured that yourself?

Good work!

Legato626 · Post by **Legato626** » December 21st, 2005, 1:53 pm

See this is what it looks like when you get it all done.

I used a lot of wire and hot glue to put all the wire mesh on. =)

AndysAutoSport · Post by **AndysAutoSport** » December 21st, 2005, 2:01 pm

That's the stuff baby!

Looking good.

You could use bondo and just dap it onto the rear of your bumper to secure the wire mesh next time, it's a lot easier and lasts a lot longer hehe.

projectmx · Post by **projectmx** » December 21st, 2005, 2:07 pm

i love that front bumper but it was sucha pain how low it was stock cause it was constantly scraping it on bumps and driveways and such

Legato626 · Post by **Legato626** » December 21st, 2005, 2:22 pm

Thats why you have to go at angels to get out and take bumps slow. I am going to be lowering my car.... So there are going to be places i will not be ABLE TO GO ANYMORE!!!!!