Page 1 of 1
Where to install an oil catch can ?
Posted: November 5th, 2005, 9:31 pm
by fir3
Where to install an oil catch can in a 1.6 4cyl ?
I found how to install in a v6 mx3...
Can someone post a photo where is the PCV Valve?
Where is the "connection to inlet manifold" ?
In a 1.6 16v 4cyl DOHC...
Posted: November 5th, 2005, 10:06 pm
by ryanlindenberg
PCV valve is on the valve cover. it as a little hose coming out of it.
Posted: November 7th, 2005, 10:22 am
by fir3
I think I found...
Should I install the oil catch can between this and the connection ?
Posted: November 7th, 2005, 11:02 am
by ryanlindenberg
i don't know, but out of curiosity, why are you installing one?
p.s. that is the pcv valve that you have circled.
Posted: November 7th, 2005, 11:12 am
by fir3
-maintaining the correct octane rating of your fuel without being degraded by engine oil
(which doesn’t burn cleanly)
- keeping the intake manifold, valve tops and cylinders clean.
Posted: November 7th, 2005, 6:42 pm
by sk8erdude28
I just use a fuel filter. It's from Mr.Gasket. It's a universla fuel filter. I just cut a peice of the rubber and stick it in there. Seems to catch a lot of oil.