Page 1 of 1
je50 and kf34
Posted: August 10th, 2005, 10:09 pm
by sysopt
Hi, I just picked up a klze for my protege (a cousin of the mx3) and it came with the mx-3 wiring harness, a je50 air flow meter and a kf34 distributor. Could someone help me out with getting the right us spec ecu? thanks.
Posted: August 11th, 2005, 9:14 am
by mxmaz
Posted: August 11th, 2005, 7:24 pm
by sysopt
I need to get this up and running asap even if a us spec ecu is not the best option. Which us spec ecu(s) will work (like k8xx)?
Posted: August 11th, 2005, 9:50 pm
by Custommx3
The k8 will work, just not as well as the KLZE one would.
Posted: August 21st, 2005, 12:41 am
by sysopt
I'm getting a probe v6 ecu and air flow meter from 93 because it seems like that will be the most closely calibrated for this engine. Should that work fine with the kf34 distributor?
Posted: August 21st, 2005, 1:38 am
by jschrauwen
I'll take a stab since you're looking to find one quick and easy that will work with the ZE on a short term or even longer basis. Not sure how interchangable those probe parts are with Mazda wiring config. Although you haven't mentioned which IM and TB you'll be using, I'd source an MX6/626 ECU and VAF. ECU - KL01, VAF - KL02. Should be easy enough to find in junkyards. BTW, must be that combo to work with each other. Disty type shouldn't be a player in this scenario.
Posted: August 21st, 2005, 2:46 am
by killerpickle
I ran the ECU and VAF from an MX6 for a while on my ZE setup and it worked okay. The ZE ecu and je50 VAF is much better and worth the money though.