MX-3.com

for air intakes what years of other model cars would fit the mx-3?

awesome... so is there a lot of modification involved to make it fit? and will it fit with a 1.8L engine bay, cuz i noticed you have a KLZE

the other one i realised that i think its the 91 civic might fit with modification to the piping.. i saw it on endocyc'c cardomain page

Here's a good how to courtesy of babybluemx3...

it is very easy to install and shouldnt take you more than 2 hours for sure.

http://www.cardomain.com/memberpage/211008/4

what do you cut the pipe with?

a hacksaw works

Use a light sabre, will be much faster.. but if you cant get your hands on one.. a hacksaw as mentioned or a reciprocating saw (sawzall) will do the job.. or.. if you have access to a band saw.. that would probably work the best. Though I just use my light sabre

Tunes67

thanks, I would use my light saber but I have the double-ended kind, which makes it difficult for any practical uses other than whoopin up on some jedis.

Has anybody tried the short ram version of this intake? I don't want to go through all the trouble in installing the cold air.

I know people that have the short ram intake and it works fine, but the CAI is really not that hard to do. Took me all of 2 hours.

thanks for your input, I was getting worried from this post:

http://www.mx-3.com/phpbb2/viewtopic.ph ... ght=intake

Are you refering to the same 91-93 integra intake but just the short ram version?

same one.. for an Integra 90-93

my intake....its from a 88-91 civic/crx si. I cut it to fit and bought couplers of the proper size from hosetechniques.com