Page 1 of 1
Alignment
Posted: April 8th, 2003, 12:21 pm
by Bri94GS
My way was pulling to the left, so i brought it to get an alignment today. When they finished, I have a note on my slip that says "CASTER ADJUSTMENT IS MAXED, POSSIBLE BENT LOWER CONTROL ARM, THE CAR MAY DRIFT TO THE RIGHT", but yet it still drifts to the left...not really sure what the lower controller arm is...any suggestions? thanks
Re: Alignment
Posted: April 8th, 2003, 1:53 pm
by Sonicxtacy02
My first response would be did they actually do the alignment? If they did it was a waste of your money. the didnt correct the alignment and they didnt fix the needed repairs so once you replace the control arm you'll just have to get the car aligned again.
Re: Alignment
Posted: April 8th, 2003, 7:12 pm
by jaydog5678
You may have a radial pull. A tire could possibly be the problem. A temporary fix, if the alignment was done correctly, rotate the tires. If it still pulls, than you need to start looking at new suspension parts. Did they give you an alignment readout?
Re: Alignment
Posted: April 8th, 2003, 7:15 pm
by Bri94GS
yea, i have a read out, and they said they'd align it again once i got the part in....
Re: Alignment
Posted: April 8th, 2003, 11:05 pm
by David Coleman
Moved to the forum that deals with suspension and not engine performance.