Page 1 of 1
upper thrust bearing on ZX2 install?
Posted: February 27th, 2003, 12:20 pm
by H-Stock MX3
how many of u reused the old stock MX3 bearing? When u reuse it will u have to do any grinding? I know u have to when u use a ZX2 bearing, but what about the stocker?<p>Joe
Re: upper thrust bearing on ZX2 install?
Posted: February 27th, 2003, 3:14 pm
by zytariuk
...you just answered you're own question.
Re: upper thrust bearing on ZX2 install?
Posted: February 27th, 2003, 3:40 pm
by Mradio
you will not be able to use the stock bearing, because the diameter of the zx2 strut (not sure what that part is called) is bigger, the stock bearing will not fit over it. You will have to grind our about 2mm from the upper spring seat (make it round), and you gotta get zx2 bearings.
Re: upper thrust bearing on ZX2 install?
Posted: March 12th, 2003, 1:47 am
by zytariuk
...to clarify, you only need two (2) ZX2 thrust bearings for the front only.