MX-3.com

Okay, so I got my lovely x3 racing altezzas, and am going to install them wednesday properly. So I heard that virtually everyone has problems with condensation and water drops getting inside the lens. SO...where exactly do I seal. Around the entire seem, I would guess. I was thinking of using some clear waterproof outdoor silicone. Any ideas? Im going to take some pics of this procedure as simple as it is and post soon... later,

Every point where the clear lens connects to the black plastic should be sealed. I dont think you need to do the entire thing. Clear silicone will be fine.

okay, I'll give that a try.

that really doesnt make sense to me so ill refraise...<p>everywhere there are plastic tabs sliding into the black backing should be done. You can probably see the holes if you look at them.

I used silocone in the winter and in hasen't leaked yet
should work

i bought silicone today and am going to do it and take pics...maybe post them in the next couple...