Custom Engine Bay
Posted: July 14th, 2003, 8:47 pm
Hey everyone,
I'm looking into having my intake manifold and valve cover custom powdercoated with some pretty intense designs... which I would rather not reveal until I get your opinions on pricing.<p> I was quoted at $225usd for the IM and VC both custom powdercoated by an artist... and more elaborate designs went up to $250, and then a VERY elaborate and detailed design at $300usd. <p> I'm sure I would opt for the $225 designs or the $250, depending on which design I like best... However, my question to everyone is, is this a ridiculous price to pay or is this reasonable for all of the prepwork, design and finishing that will go into this custom job... <p> If I could get a few informed opinion asap, that would be VERY helpful!!!
I'm looking into having my intake manifold and valve cover custom powdercoated with some pretty intense designs... which I would rather not reveal until I get your opinions on pricing.<p> I was quoted at $225usd for the IM and VC both custom powdercoated by an artist... and more elaborate designs went up to $250, and then a VERY elaborate and detailed design at $300usd. <p> I'm sure I would opt for the $225 designs or the $250, depending on which design I like best... However, my question to everyone is, is this a ridiculous price to pay or is this reasonable for all of the prepwork, design and finishing that will go into this custom job... <p> If I could get a few informed opinion asap, that would be VERY helpful!!!