MX-3.com

I just picked up some racing seats and I was wondering how everyone made the brackets for their seats because I know that some of you put seats in your cars. I have the reclinable ones and they are on sliders. Any help would be appreciated.<p>Thank,
Jeff

jeff abrams explained how he did his.......he drilled the holes in the stock seat rails & screwed it in

I haven't done this myself, but i believe you just mate them up to the brackets from your old seats, do a search 'cos i remember reading it not so long ago

Heehee! guess i must've typed too slow

the way I did mine was to use the stock rails and make an adaptor using 2 strips of steel to bridge the gap between the 2 rails. The rails are not level with each other so one sits lower than the other. I had to make spacers to raise the 1 side up so they were level. Making cardboard templates helps to mark drill holes. 1 set of holes is for the adaptor to rails and the 2nd set is for adaptors to seats. The seats now sit about 1/4" higher than stock but is not visually or physically noticable.

thanks guys. I will be getting them in the car sometime this week.

<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by mx3optidrive:
thanks guys. I will be getting them in the car sometime this week.<hr></blockquote>
how will you be doing them....what method did you decide?