MX-3.com

Hey hows it going eveyrone . I jsut wanted to know if anyone has bought the lenses from Corksport , for the front signal lights on the front bumper.
It says all you need to do is use a blow dryer and the front lense will easily come off ... Is this as easy as it sounds because it is 10x cheaper than the actual light!
So let me know on how anyone has put them on or any info to help me out thanx alot

Yes it is pretty easy to do, just takes a bit of patience. Check out Luc's GSR site, found on the links page, because there are some instructions on how to do it.

<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by Imraan:
Hey hows it going eveyrone . I jsut wanted to know if anyone has bought the lenses from Corksport , for the front signal lights on the front bumper.
It says all you need to do is use a blow dryer and the front lense will easily come off ... Is this as easy as it sounds because it is 10x cheaper than the actual light!
So let me know on how anyone has put them on or any info to help me out thanx alot<hr></blockquote><p>
i bought them from corksport and installed them myself....it is a 5 min job

Something I'd also suggest is spraying the inside with a nice metalic silver and then a clear coat. The'll look a lot better.

I would try a heat gun if I were you (from the hardware store, very cheap) instead of a regular hair dryer because it take a long time to melt the gel/glue especially if it has been on there for almost 10 years... the heat gun gives you a little extra advantage! Good luck - mine came out great and so will yours!

hey guys thanx so much now all i gotta do is order them ! i figure they are nice so i guess i will get them thanx alot se ya