MX-3.com

heres my car pics and some friends to sorry about all the posts I finally made a crappy page just to get my pics online but here they are finally. the next seat is almost done then comes the door panels. <A HREF="http://drewlude33.tripod.com/carz0rz/" TARGET=_blank>http://drewlude33.tripod.com/carz0rz/</A>

They look great. Where did you find ther material to do this??<P>

I found the material at a local fabric store it was 7 bucks a yard and i bought 3 yards per seat im gonna have just barely enough red vinyl to do my door panels. Ill get pics up of my door panels when I finish them.

look great but you neeed to hid that power wire......for your amp......just pull up that plastic part alittle a stick it up there<BR>that is what i did<BR>jason

It takes about 4 days a seat. Yes i cut all the old seat covers at the seams and cut the vinyle EXACTLY the way the old material was shaped. I also had to buy a hog ring tool and hog rings to reattach everything but thats only about 10 bucks. Total to do the front seats has been about 100 bucks because of the thread I used A LOT of expensive thread. The actual vinyl was only about 50 bucks and I have some left over.

Hey again guys I just wanted to give a warning to anyone who is attempting this. MAKE SURE YOU HAVE THE PIECES LAID OUT IN THE RIGHT PLACE BEFORE YOU START TO SEW!!!!!!! I accidently put a piece that was supposed to go on the front in the back and because of it I added another 3 hours of work and its a little lamer than it would have been if the project went smoothly, ill show pics of my mistake once I get the camera back! later fellas