MX-3.com

hey guys, i just wanted to see everyone's performance mods (no body kits, wings, etc) ie. turbo, nos, swap, etc. And how much $$ did it cost you to go as fast as you are now (in 1/4 mile)
so post your mods and $$ estimates and track 1/4 mile times. thanks guys.

So far I'm at about $9500, and the car isn't even running right now.

$10.00<p>fast enough to get to school.

Uhh...well over 10k i'm sure with all my go fast stuff. Havent really tried to add it up....Maybe after I finish some other paperwork I have to do with the group buy I will look into that...

$10k CDN<p>$5K on KLZE
$5K on System/CarPC and Neons<p>$5K to Purchase the Mx-3 + Custom Plates<p>[ September 08, 2003: Message edited by: Nd4SpdSe ]</p>

TOO MUCH. and mine doesnt run either I think I am around 9 including purchase of car and paint.

Hrmmm... Well grand total.... car cost mne 6k...<p>BPD swap was 1k with parts... 200 for a uunderdrive pully... 20$ for intake... i just put in my flywheel.. so i hope to be able to post somethign lower than my 15.9...

around $15,000.00 CDN including $8,400.00 for the car.

whats with all the non running turbos?<p>I paid probably 7000 dollars for everything, minus the car, including my leatherette interior which will be done friday...<p>[ September 09, 2003: Message edited by: killerpickle ]</p>

so far just on engine stuff about 6,000
3000 on looks(body kit and rims)<p>and another 5000 this winter

CAR 5900$
BPT swap 3800$
never tried it on the 1/4
more engine mods to come<p>mods on car(wing, rims,altezza sound system etc)
5000$<p>total arround
15000$

(prices in USD):<p>Car: $500
Bringing car up to code: $200
KLZE engine: $1041
KLZE replacement stuff (axles gaskets, seals, belts): $400ish
KLZE ECU: $250 (from lazyie)
ACT Clutch kit: $350
Redline synthetic fluids: $60
Custom-made intake: $70<p>Total cost thus far: $2771 for KLZE swap stuff.<p>Still needed:
Millenia (curved neck) intake manifold: $150ish
Pace****ter headers: $220
MX6 transmission: $200ish
2.5" exhaust w/my JUN titanium muffler: $450<p>so about another grand and i'll be done with the motor work stuff.<p>As for 1/4 mile times...right now I run a 14.8 with the stock manifolds and just a cone filter (the intake isn't on yet). I expect to run a 14.0 or better with all the other stuff installed, when all is said and done.

double post...my bad<p>[ September 11, 2003: Message edited by: Gro Harlem ]</p>

Shoot I am the worst off all. All I have is an intake and a exhaust typical you know. About $400 with the prm intake an a ac revoloution muffler. 1/4 time is about the time for a person to take a nap. I'm probably going to sell it after I get my cards paid off and get a v6 if I can find one. I atleast have some 17 enkei rf-1 though.

$2000 USD on car
around.. $1700 on audio, interior, and engine maintenance and replacing worn parts.
sadly, i don't have any performance parts! but the v6 is fast as hell stock. o yea, i'm surprized at how much you guys pay for your cars! LOL
~ sam