Page 1 of 1
Which bearing/IM
Posted: August 24th, 2004, 3:05 pm
by kenped8
Which release-bearing did you use for your klze engine with k8 tranny?. The 626 release-bearing is 2mm shorter than the k8 one. Can i use the one from 626? And are the runners on the 626 IM just as big as the ones on the klze, or will i have some power loss?
Re: Which bearing/IM
Posted: August 24th, 2004, 6:21 pm
by PATDIESEL
The runners are slightly smaller on the 626 then the ZE, probably not much loos though. As for the bearing
Re: Which bearing/IM
Posted: August 25th, 2004, 4:09 pm
by kenped8
That`s what i also thought about the 626 IM. It`s the only one i can get here in europe that is bigger than the k8, so i will have to go with that one. Did anybody have the "problem" about bearing?
Re: Which bearing/IM
Posted: August 25th, 2004, 6:44 pm
by IanL
Is this release bearing you're asking about the Clutch Release Bearing (Throwout Bearing)? Because I've just checked the Parts List and the same part, Collar Clutch Release LF01-16-510, is used in the MX-3, the MX-6 and the 626.