MX-3.com

Anyone know the color of wire and where it goes that controls the clocks memory? The clock works when the car is on, once its off, back to default. EVERYTHING else works fine. Interior lights, guages, lighter, everything. Fuses are all fine. Please help.

No I don't but I bet if you searched around in the dash wiring diagram in the online manual here at MX-3.com you could find it.

I checked it but it I was unable to tell which one or color was the constant.

it was hard to find but i have a chilton's auto repair manual for my mx. all kinds of diagrams and instructions.

There's probably a fuse out on the memory power lead.....that's my guess. Just like a CD player that has two power leads - one for memory, and one for power on - I bet the clock is set up like this too.

the clock is with the interior lights, if they were working then the fuse might be bad, it happened in my car

wait I hav this same problem... is it afuse? i left two red wires unplugged to nothing i bet these are for the clock the constant and intermittent is this correct? ( i just installed a new cd player and i didnt know where tose two red wires went so i left them unpluged

I had the SAME problem....ALL th wires should be used.... It's been a while, but I do remember that without a red wire my lights didn't come on at all!!! My clock stays on 24/7 though the way I have them wired. My dash lights didn't come on either till I figured what wire went where, I just hooked up one of the reds to a blue...I can't remember though..If i do then I'll get back to ya on it.