MX-3.com

When i put my ze inthe two solenoids were broke on my ze so i just swapped over from my k8. I knw they are justsolenoids and can only be operated when the ecu sends them power but my question is are they different. Could i not be getting the right vris valve opening at the right time causing me to lose pwer? Any help would be nice thanks Steve

Go under the hood and rev the motor by hand. You should be able to watch the VRIS open and close, as for your VRIS points they are incorrect and that does make you lose power but the ZE ecu is still loads better than the DE ecu.(9 degrees of timing advance, No limp mode)

So you are telling me the solenoids are different? If so can i get some ze solenoids? I haveopened the hood and visually watched he vris open and close, i know they work but at the right time is my question? I could probably reference it with the online manual. F-2 100 Any feed back would thanks Steve

no they are the same

they are the same, i did the same thing, one of my ze's solenoid was busted so i swapped it for my k8, works fine

<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by dewthis:
i know they work but at the right time is my question?<hr></blockquote><p> <blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by lazzyie:
as for your VRIS points they are incorrect and that does make you lose power<hr></blockquote>

<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by dewthis:
I knw they are justsolenoids and can only be operated when the ecu sends them power<hr></blockquote><p>You said it yourself. The timing is determined by the ECU. If your ZE engine has a ZE ECU, I don't understand how the timing could be wrong.<p>[ August 12, 2003: Message edited by: IanL ]</p>

the are the same .. just reiterating