Page 1 of 1
ze idle issues
Posted: May 27th, 2003, 1:21 am
by Buff1110
if im using a ze tb which isc should i use (this is on my klze motor)
and how do u adjust jumping idle, mine jumps from 1000-1200 and back again like up down up down...
Re: ze idle issues
Posted: May 27th, 2003, 2:14 am
by ghandi1981
u have the ze ecu??? mine did that until i got the correct ecu.....<p>aj
Re: ze idle issues
Posted: May 27th, 2003, 1:17 pm
by lazzyie
The jumping idle could be due to the iac differences(switch ecu) or a vaccum leak, listen and spray around the tb and im for leaks.
Re: ze idle issues
Posted: May 27th, 2003, 2:11 pm
by timpronk
your idle jumps most likely due to the throttle position sensor being set incorrectly (or left at the setting of the k8)<p>You will need to adjust the tps and idle settings. Lots of people say no dont do this, as does the manual. But they are not taking into consideration that you have swapped the engine.<p>you will have to look in the online shop manual jeff has provided for the details on how to do this.<p>hope this helps ya
Re: ze idle issues
Posted: May 30th, 2003, 12:43 am
by Buff1110
which isc do i use though, k8 or ze?
Re: ze idle issues
Posted: May 30th, 2003, 1:26 am
by lazzyie
<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by Buff1110:
which isc do i use though, k8 or ze?<hr></blockquote><p>I don't even have that hooked up. My idle is set at 800rpms. Definately try the tps adjustment. The poor man's adjustment instructions are in the V6 FAQ. You get that ze ecu in yet?
Re: ze idle issues
Posted: May 31st, 2003, 1:08 am
by Buff1110
yea the ecu is in and works perfect. fans click on and off
. did u leave the ze isc in then and just not plug it in?