Page 1 of 1
Hotshot headers from a Probe GT to MX-3
Posted: April 24th, 2003, 2:22 pm
by Hex3
I have come across a set of hotshot headers for a probe GT, i was wondering if they will fit a mx-3 with a ze, i dont know if they are going to be longer or drop further under the motor???? I am also going to get a cat-back exhaust so if it is to long then i can get the piping shortened on the piping after the headers. If anyone has any ideas or suggestions it would really help me out.
Re: Hotshot headers from a Probe GT to MX-3
Posted: April 24th, 2003, 2:27 pm
by novadoc
they should fit just fine, your just gonna have to relocate your cat back a bit
Re: Hotshot headers from a Probe GT to MX-3
Posted: April 24th, 2003, 2:37 pm
by Custommx3
heres a pic of them, you will have to relocate.<p>
Re: Hotshot headers from a Probe GT to MX-3
Posted: April 25th, 2003, 6:26 am
by zevirii
They fit fine moved .. Your CAT will have to be moved back about 6" or so.
Re: Hotshot headers from a Probe GT to MX-3
Posted: April 29th, 2003, 9:54 pm
by lstpier
What about the fitment to the EGR valve? Does the supplied plumbing fit right up?
Re: Hotshot headers from a Probe GT to MX-3
Posted: May 1st, 2003, 1:27 am
by pcperez83
can you actually feel a power difference?
Re: Hotshot headers from a Probe GT to MX-3
Posted: May 1st, 2003, 10:24 am
by lazzyie
Hotshots are for off road use only they dont have an egr tap. Headers on k series motors make a noticeable top end difference.
Re: Hotshot headers from a Probe GT to MX-3
Posted: May 1st, 2003, 11:04 am
by pelado
Funny, my Hotshot rear header has both an O2 bung and an EGR connection.