MX-3.com

http://www.outlaw-engineering.com/Pricing.htm<p>
does it work or just another gimmick?<p>is it worth it?

I am going to install it , but I will put a valve in the tb preheat lines

everyone that i have talked to with them installed has loved them, havent heard a complaint yet. they lower the intake manifold temperature to the point where u can drive for a few hours, pop the hood and be able to put ur hand on it and not getted burned, also they can be taken on and off so there reusable. good investmant.

becareful with the throttle body spacer, I have it on my ze and it doesnt fit right little gaps cause vaccum leaks. Not to big of a deal because I have lotsa silicone to fill in the hole

How high does it raise the IM?<p>~A

1/4" inch, We've had these for years, they really do work.

is thier anywere that would have it so i dont gotta buy it from internet for example local speedshop or soemthing?

<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by MMike:
is thier anywere that would have it so i dont gotta buy it from internet for example local speedshop or soemthing?<hr></blockquote><p>No. They might have bulk material but not these specific spacers.

I have these as well, putting them on my KFZE.

I installed them recently.....a pain in the a** if you are removing your IM for the first time and you don't have paper thin hands. All in all incident free except that my idle is very unpredictable and sparatic. Anyone have any thoughts on that???

I've had them in both of my mx-3's. They make a huge differance in the IM temperature. They seemed to be of very good quallity. I am very pleased with them and would recommend them to everyone.