Page 1 of 1
spark plugs with zex att.sneed
Posted: May 27th, 2002, 6:16 pm
by curtklze
what is the best type of spark plug to use with a KL-ZE and a 75h.p. shot of zex nitrous<P>The NGK book says that ZFR5F-11 is stock for a 95-99 Millenia. I was thinking about a<BR>ZFR6FIX-11 which is an Iridium plug that is 1 heat range colder than stock.
Re: spark plugs with zex att.sneed
Posted: May 30th, 2002, 5:13 pm
by sneed
not sure try to use the zex one that are pre gaped if not the ir ones will be fine the have a fairly high melting point make sure ur wires all in good shape if u dont remiber the last time u changed them change them and get a air/fule guage these thing will help
Re: spark plugs with zex att.sneed
Posted: May 30th, 2002, 8:49 pm
by 93mxrgs
i would not run that high of a shot on a kl-ze, as they have had sum problem with detonation due 2 the higher compression rate... on probetalk most ze owners say a 50 is the biggest that can be used safley, and repeatly... there have been no ZE users that have sprayed for me than 2 years.... most burn valves long before that... just sumthing to think about..
Re: spark plugs with zex att.sneed
Posted: May 31st, 2002, 3:15 pm
by sneed
check out probetalk.com they will have the info and there a good site
Re: spark plugs with zex att.sneed
Posted: June 5th, 2002, 1:53 am
by chris_pulay
Hey Curt,<P>Have you used your zex yet?
Re: spark plugs with zex att.sneed
Posted: June 5th, 2002, 2:37 pm
by curtklze
Not yet, I just finished the car and I ran out of money. After I sell my 86 fiero GT and pay off the engine I will get the zex.
