Page 1 of 1
Put the KL-ZE , and the accessory ....
Posted: November 20th, 2001, 12:45 am
by racefear
I will put this motor in two month and I want to say what it's recommended to put with the 2.5 L KL-ZE?? <BR> I think of a : - PRM Intake<BR> - Torsion bar<BR> <BR>
<P><A HREF="
http://www.multimania.com/modifiedcar/Mazda_MX3_MY9.jpg" TARGET=_blank>My CAR :</A>
Re: Put the KL-ZE , and the accessory ....
Posted: November 20th, 2001, 1:39 am
by killerpickle
<A HREF="
http://www.corksport.com" TARGET=_blank>www.corksport.com</A> <A HREF="
http://www.prmracing.com" TARGET=_blank>www.prmracing.com</A>
Re: Put the KL-ZE , and the accessory ....
Posted: November 24th, 2001, 1:30 am
by racefear
Re: Put the KL-ZE , and the accessory ....
Posted: November 24th, 2001, 4:03 pm
by Zoso124
ok ready, shave flywheel, get an Underdrive pulley, replace motor mounts with stock ones or get the stiffer Mazdaspeed ones, you can also inject your stock ones to stiffen them up. Upgrade the clutch cause the stock one can't hold up long with the increase of hp and torque, Go with the ACT Stage II first next choice would be Vitek or Centerforce. While you at it you might as well replace the axles with some reman's.
ummm that will get you started! good luck
Re: Put the KL-ZE , and the accessory ....
Posted: November 26th, 2001, 12:34 am
by racefear
Thanks for your reply, this will help me !<P>MY CAR :<BR>
Re: Put the KL-ZE , and the accessory ....
Posted: November 26th, 2001, 12:39 am
by racefear
Thanks for your reply, this will help me !<P>MY CAR :<BR>
