Page 1 of 1
prm install ?
Posted: December 27th, 2002, 7:45 pm
by Mx-3SHO
I just got a prm intake and the only problem i have run into is the brass nipple for the vacume line that comes with the sylicon spacer. the problem is that i don't have a vacume line to hook up to it is my car missing one or is thern not one for it i have a 92 gs
Re: prm install ?
Posted: December 27th, 2002, 8:01 pm
by killerpickle
the vacuum line, is the one that you took of the stock air box before you tried to install it. If you check my website I have some better instructions for installing the prm intake, the ones they came with are next to garbage.
Re: prm install ?
Posted: December 27th, 2002, 8:48 pm
by monty73741
DIDNT THINK THAT THE GS AD A VACCUM LINE THOUGHT IT WAS ONLY THE RS
JASON
Re: prm install ?
Posted: December 27th, 2002, 9:02 pm
by Sonicxtacy02
the vac. line makes no difference anyway... Dont worry about it
Re: prm install ?
Posted: December 28th, 2002, 12:34 am
by killerpickle
I dunno, if I take the vaccuum line off it will sometimes make the idle fluxuate a few hundred rpms...
Re: prm install ?
Posted: December 29th, 2002, 12:07 am
by mattster
there is a vacuum line found on the GS and i seemed to have noticed the difference when it wasn't connected because my idle would drop too low sometimes, and when i put it back on it was ok... maybe just a coincidence
.
Re: prm install ?
Posted: December 30th, 2002, 12:00 pm
by Mx-3SHO
well the mean problem is that i didn't have to take a vacume line off my old intake and i don't see one just lying around so were does the other end of the vacume line attache to.<p>[ December 30, 2002: Message edited by: Mx-3SHO ]</p>