Page 1 of 1
Shift light install
Posted: September 12th, 2004, 6:33 pm
by BEERDDWR
I just installed an auto meter shift light and wanted to confirm the wire I need to splice on the ecu to get the rpm signal. I think its pin b2 the dark green one on the largest plug but I’m not sure so if any one knows I’d really appreciate the help so I don’t blow it up.
thx
Re: Shift light install
Posted: September 12th, 2004, 7:01 pm
by Limegreen mx-3
I think the tach signal is the yellow/blue wire could be wrong can anybody confirm this laters
Drifter MX-3
Re: Shift light install
Posted: September 12th, 2004, 7:12 pm
by BEERDDWR
Ya see I would have been wrong and i know the ecu would go pop and I would have to replace it.
Thx for the reply man.
Re: Shift light install
Posted: September 12th, 2004, 11:15 pm
by Typhoonk
Tach -> Yellow/Blue at Distributor plug
probably the same wire at the ECU. But I would test it first
Re: Shift light install
Posted: September 14th, 2004, 2:49 pm
by mxprecidia
whered u get the light?
Re: Shift light install
Posted: September 15th, 2004, 1:25 am
by BEERDDWR
ok so i tried tapping the wire @ the ecu and it didn't work?????
.
I got it with a SportComp Auto meter moster tach at a garge sale in Terrace B.C.
Any other ideas would be greatly appreciated.
.