Page 1 of 1

here is what i got

Posted: May 2nd, 2004, 10:32 pm
by philcosta
hey guys here is what i purchased do i need anythning to bring the performance up?

i have a 93 bpt GTX with the bpt ecu and IC'ed
i just purchase

Greddy profec b spec 2 boost controler
greddy turbo timer
autometer air/fuel gauge
autometer boost gauge
and i am also making my exhaust 2.5 inches and i have and high flow catco

thanks

Re: here is what i got

Posted: May 2nd, 2004, 11:19 pm
by Shady469
when turning up the boost i would recommend an EGT gauge and/or a wideband O2 sensor when tuning. the AM a/f gauge does ok but is really only very accurate in the stoich range (believe me: it took blowing two pistons apart to find out the hard way). you could always get it dyno tuned but the cost of that compared to the wideband made by innovative motorsports (LM-1) www.tuneyourengine.com is almost the same where as the LM-1 can be used all the time or whenever you want to adjust boost.
another thing: upgrading to a 2.5" downpipe and exhaust netted me 4 more PSI than stock with no boost controller.

Re: here is what i got

Posted: May 2nd, 2004, 11:33 pm
by ryanlindenberg
protege transmission and ACT clutch would be good.

Re: here is what i got

Posted: May 3rd, 2004, 5:59 pm
by philcosta
i have a protege lx tranny and a ACT double pressor clutch and 2.5 inch exhaust with and high flow cat will be done in 1 month already ordered my mendrel bends

i also have a rx7 2 gen 195 lph fuel pump

i am getting every thing installed here

TAPP AUTO
and it will dynoed

<small>[ May 04, 2004, 01:41 PM: Message edited by: philcosta ]</small>