MX-3.com

i can drive regular if i dont hit the gas a lot. but once i floor it, the rev shoots up fast. i dont want to pay a lot to fix this. what can i do?

take a cab <p>Sorry, but if your clutch is out, nothing else u can do but replace it.

The clutch is gone for sure and there is nothing you can do about it.<p>Your best bet is to get an ACT clutch if you're going to drive your car hard.<p>You're looking upwards around $900can to buy it and get a shop to put it in. Don't forget to get the flywheel resurfaced, otherwise you'll need another new clutch in no time.

Screw the ACT, get an OEM one dude. The clutch itself will cost about 120 bucks and the installation, i have no idea. Ive never had to have one installed, i do it myself all of the time. About the flywheel, its not a necessity to have it resurfaced, only if it is in bad shape. Ive never had any flywheel resurfaced and the clutches are still going strong.

i had my cluth and slave cylinder replaced and had my flywheel resurfaced for $525.00 US

Why would u have to replace themaster slave cylinder if your clutch is slipping.

who said mine was slipping

sorry 4 mistype

In reference to getting the flywheel resurfaced:<p>if there are nicks and scratches on the flywheel, they can cause premature wear on the clutch,<p>i had mine done and it comes back like a mirror, so spend the extra money and have it done.

ClutchMasters here in portland quoted, $350 for clutch, throw out bearings, researfaced flywheel, installed.<p>Get a couple of extimates since it can very alot.<p>-Cybin