MX-3.com

I found one, 2000 CLK AMG supercharger in TX for 400 bucks, the guy says it's mint.

Thats kinda expensive. I picked up a mint one for 250 a few years back for my failed SC project. Keep looking on eBay etc, they are cheaper then that and usually dont require rebuild for 200,000km

thanks will do...

It's been a while since I've updated my worklog, done quite a bit. I've done Eibach lowering springs and new upper strut mounts front and rear, new power steering rack, Wytbishop bushings front & rear, PBR ceramic pads with new rotors. Also got a pair of reproduction SRD rear tie bar & front cross member. BNIB drivers OEM leather seat cover, power folding mirrors, center console with cup holder.

Also didn't take much pictures as my hands were dirty most of the time, here is some that my bud took with his cell.

The guys at JPG exhaust were pretty cool here is a few pics of the exhaust being installed.








Here is me torching the rear spindle bolts off at the shop. A bit of a pain in the rear, the rest of the bushings where really easy to install. Didn't get any more pics but I'm installing new heat shields and I will snap some more shots when I'm underneath the car.

Went to the Sunday meet and got some rare leather seat covers for only the drivers side Wish I can find a new passenger side set of covers to match unfortunately probably I will never find it. Stay tuned on the passenger seat restoration.

I will have to dye the beige center console cup holder black or find matching spray paint.

Or you could buy a real black one!

I might have an extra (or 3) laying around. lol

Well PM'd

You wouldn't happen to have a BNIB passenger side leather seat covers

This car is SEXY. It makes me wish my red one wasn't so faded On a terribly unfortunate side note, I removed(and subsequently LOST) my MINT fire shielding from the hood... I lost it in my most recent move.

thanks

Your seats look nice! good work

Today had to fix a Porsche Carrera S, here is a pic of me returning it to the customer.



Also got my guy at vinyl craft to repair the drivers SE door panel that john sold me.







Dave finished dying centre console black.

Installed my power folding mirrors here is the a link to my folding mirror install.

http://www.mx-3.com/phpBB3/viewtopic.php?f=17&t=78015

vinyl work looks good