MX-3.com

Posted: **June 17th, 2014, 7:38 pm**

Yes, but I use an external coil out of a mustang and am using an MSD Ignition module... So I'm not sure if the disty without coil plays well with the original computer or not. I run the wire that would usually fire the disty's ignition to the external coil and then set up the MSD which takes over for the rotor.

Posted: **June 17th, 2014, 8:33 pm**

RogueWolf wrote:I grabbed one off of the UK Ebay. Fit perfectly. It's an OEM, HEI mod.

The cap is still being produced by Mazda, I only now found out that I could have ordered it directly from my local Mazda Dealership... because it's not for a North American car they will not accept returns on the part if it doesn't work. (At least my local dealership will. )

How much is it through your dealership, I tried at work and no-go state side to order one in

Posted: **July 3rd, 2014, 10:58 pm**

RogueWolf wrote:I grabbed one off of the UK Ebay. Fit perfectly. It's an OEM, HEI mod.

The cap is still being produced by Mazda, I only now found out that I could have ordered it directly from my local Mazda Dealership... because it's not for a North American car they will not accept returns on the part if it doesn't work. (At least my local dealership will. )

Just some info for anyone else out there, I picked one up and it will not fit a DE disty even with the coil removed, bolt holes on the caps are in different positions.

MX-3.com

[WTB] - 7 Post Distributor Cap

Re: [WTB] - 7 Post Distributor Cap

Re: [WTB] - 7 Post Distributor Cap

Re: [WTB] - 7 Post Distributor Cap