There I got one atleast.
Will try to find the two I originally posted and put them up again.
nope-mx3
Finally got the polished manifold installed
John,jschrauwen wrote: Were you or had you looked at smoothing the inside of the IM so as to improve air flow and assumably performance?
I believe you do NOT want to polish the inside of an IM, rough is better for atomization and would minimize fuel pooling, i thought the same thing, when i installed a Edelbrock Performer IM on my Trans Am i t was really rough inside prob rougher than the outside.
A asked the same question and the guy i bought it from said "Dont Bother".
As for the powder coating in Crome, im interested in this as well, i have a curved neck IM that i have taken absolutly all the casting ribs and ridges off and smoothed all 6 runners (the whole runners not just the tops) out with 220. It took sooo many hours and i still have to do it all over again with 600, 800 then 1000.
More info on this would be greatly appreciated