Posted: March 6th, 2005, 5:09 pm
Right vicinty but rad hose in the way. Need to see base area of coolant filler neck. BTW, thanks M8.snellgrove wrote:http://www.snellgrove.co.uk/stuff/pictu ... 200055.jpg
MX-3.com
The Worlds First and Largest Mazda MX-3 Forums
https://mx-3.com/phpbb3/
Cooling fan starts after 2 min
Page 2 of 2
Posted: March 6th, 2005, 8:18 pm
even at this size its hard to miss the sensor
Posted: March 6th, 2005, 10:52 pm
Got it, thanks P.R., at the 4 to 5 o'clock position from the filler.
Posted: March 7th, 2005, 8:24 pm
the back is your temp thermosensor, don;t mess with thatl.. its reads the temp of the motor in a .01 to .5 volt range. mess with that and your car will run like s---.. like if your coolant is low and that sensor is not submerched it will read 0 and ecu's don;t like zero!
Posted: March 8th, 2005, 4:42 pm
so your saying swapping out the neck for the k8 one is a bad idea chopper??? cause its should be a basic swapover.
Posted: March 8th, 2005, 6:23 pm
no its ok to swap necks.. pain in the but tho,, i just tapped mine took all of 5min to do.
Posted: March 14th, 2005, 8:03 pm
tapped yours, so you grabbed the sensor from the k8 grabbed a drill bit and tapped a hole in the coolant neck and shoved the sensor in then just plugged it into the ZE wiring harness? or where abouts did you wire it to?
Posted: March 14th, 2005, 8:19 pm
The harness is your K8's. So there should be a plug just hanging around the neck.