stock 1/4 mile time??

4-Cyl. Technical/Performance Discussions
torpedan
Regular Member
Posts: 1430
Joined: January 5th, 2002, 2:01 am
Location: DFW

Re: stock 1/4 mile time??

Post by torpedan »

Originally posted by FroSTeD:
Orion from the MX-3 Quebec club did
with his 1996 MX-3 RS Blue Creek Mica :

16.735 @ 81.942 Mp/H 2003

He has the timeslip and the club was at the drag with him. He wasn't using slicks or anything, he just have a CAI and lightened pulley I think.

So no, it's not necessarly 17.5 and higher for a 1.6 DOHC.
Yeah its all to the driver and the condition of the car. I am sure someone could make a 17s pass in my car if they sucked at driving =]
-torp.
I don't own a Mazda.
User avatar
Limegreen mx-3
Regular Member
Posts: 1778
Joined: October 29th, 2002, 2:01 am
Location: San Antonio TX
Contact:

Re: stock 1/4 mile time??

Post by Limegreen mx-3 »

Originally posted by torpedan:
Originally posted by FroSTeD:
Orion from the MX-3 Quebec club did
with his 1996 MX-3 RS Blue Creek Mica :

16.735 @ 81.942 Mp/H 2003

He has the timeslip and the club was at the drag with him. He wasn't using slicks or anything, he just have a CAI and lightened pulley I think.

So no, it's not necessarly 17.5 and higher for a 1.6 DOHC.
Yeah its all to the driver and the condition of the car. I am sure someone could make a 17s pass in my car if they sucked at driving =]
i had a sohc with caintake, breatherfilter, 2.25"in exhuast piping no cat, dualfriction centerforce clutch, shortshifter and the best i got was a 17.299 pretty much a 17.3 all stock i was between 17.5-17.8 in the 1/4. don't get me wrong am a very good driver beat most DOHC i race in the long run but i lost to a few dohc every now and then even with the new mods i have i dought i can get a 17.0-17.2 to get into the 16 i'll need a shot of nos 30 shot.
(12.4@118@18psi) 92 MX-3, KIA (BP-DE)Swap, Electromotive TEC II Standalone, 8,200 Rev Limit, Custom Intake/Exhaust Manifold, 1,000cc PTE Injectors, Custom Fuel Rail, Aeromotive FPR, 80MM Holley TB, MSD 8.5MM Wires, NGK V-Power #8, SC6262 Turbo, 3 in. DownPipe, Tial WG/BOV, 600HP PTE FMIC, 2.5IN Intercooler Piping, EQUUS/Autometer KIA G-Series Tran, Extreme ACT Clutch, Built BP in starting process.
torpedan
Regular Member
Posts: 1430
Joined: January 5th, 2002, 2:01 am
Location: DFW

Re: stock 1/4 mile time??

Post by torpedan »

Originally posted by Javier Munoz Jr:
Originally posted by torpedan:
Originally posted by FroSTeD:
Orion from the MX-3 Quebec club did
with his 1996 MX-3 RS Blue Creek Mica :

16.735 @ 81.942 Mp/H 2003

He has the timeslip and the club was at the drag with him. He wasn't using slicks or anything, he just have a CAI and lightened pulley I think.

So no, it's not necessarly 17.5 and higher for a 1.6 DOHC.
Yeah its all to the driver and the condition of the car. I am sure someone could make a 17s pass in my car if they sucked at driving =]
i had a sohc with caintake, breatherfilter, 2.25"in exhuast piping no cat, dualfriction centerforce clutch, shortshifter and the best i got was a 17.299 pretty much a 17.3 all stock i was between 17.5-17.8 in the 1/4. don't get me wrong am a very good driver beat most DOHC i race in the long run but i lost to a few dohc every now and then even with the new mods i have i dought i can get a 17.0-17.2 to get into the 16 i'll need a shot of nos 30 shot.
The problem with going faster is its addcitive i remeber being happy runnign a 16.5

Then it was a 15.5...

Now i know i have a problem given i am aiming for the low 11's and plan on getting throw off of the track after one run.
-torp.
I don't own a Mazda.
BEE29293
Junior Member
Posts: 21
Joined: April 29th, 2004, 2:01 am
Location: Windsor, Ontario

Re: stock 1/4 mile time??

Post by BEE29293 »

ok i went to the track yesterday in st. thomas and ran my stock 1996 rs 1.6 dohc with 17" Motegi mr7's on it. I have the time slip but can't upload right now due to scanner problem. anyways my car is auto and has nothing but rims on it therefore its stock in the engine category atleast. Well my best was a 19.240@ 71.53mph w/ a .700 reaction time so almost perfect. I was manually shifting it too at like 6000 rpm so these cars are slow lol just hammering the gas all the way down the track i ran a 19.750.
osargeant
Regular Member
Posts: 341
Joined: December 17th, 2001, 2:01 am
Location: Bridgetown, Barbados
Contact:

Re: stock 1/4 mile time??

Post by osargeant »

I think the general feeling here is that there is no way you can really make a MX3 DOHC/SOHC 4cycl fast and keep it NA.

To get decent performance you need to either swap in the B6T, BPT or the BP 1.8 motors or turbo your current engine. Anything else is going to give marginal increases at best.

The best time I managed to run NA was a 17.1 before I decided to go turbo.

mx3dohc16
15.0@93.5mph
http://www.cardomain.com/member_pages/view_page.pl?page_id=310985

<small>[ June 06, 2004, 09:50 PM: Message edited by: mx3dohc16 ]</small>
JSpec Turbo MX3 (1.6 DOHC)
http://www.cardomain.com/memberpage/310985

Port and Polished Head, Ported Intake Manifold, Valve Job, GTX Manifold, Hybrid Turbo, Cone Filter, 2.5" Exhaust, 2.5" Downpipe, ACT Street Clutch, Lightened Flywheel, MSD 6A Ignition, Boost Retard and SS Coil, Magnecor Plug Wires, Denso Iridium Plugs, UR Lightened Pulley, Spearco FMIC, Turbo XS BOV & MBC, BEGI RRFPR, Supra Injectors, Walbro 255 Fuel Pump, Autometer Gauges, Pivot Shift Light
User avatar
Casino
Regular Member
Posts: 779
Joined: April 20th, 2002, 2:01 am
Location: Sudbury Ontario Canada / windsor

Re: stock 1/4 mile time??

Post by Casino »

ah are we forgeting about nitrous ? it can make a big differnece
http://www.realtimeperformance.ca

03 miata, formally bottle fed 96 DOHC
torpedan
Regular Member
Posts: 1430
Joined: January 5th, 2002, 2:01 am
Location: DFW

Re: stock 1/4 mile time??

Post by torpedan »

Originally posted by Casino:
ah are we forgeting about nitrous ? it can make a big differnece
Nah Juice still qualifies as a altered form of induction. I think a b6 has some good n/a potential just really its overshadowed by the capabilites of its bigger brothers.
-torp.
I don't own a Mazda.
MX-3RR
Regular Member
Posts: 63
Joined: June 7th, 2004, 2:01 am
Location: Lisbon, Portugal

Re: stock 1/4 mile time??

Post by MX-3RR »

mine is running with full exhaust system iridium plugs, obx-r spark cables, ractive mushroom cold air intake, slight ignition advance,ac removed,exedy clutch and running on 195/45-15s.my best on the 1/4mile was 17,57s. and let me tell you that drag is my thing! no way that stock makes 17 something! its much much slower.
Post Reply

Return to “4-Cyl. Technical/Performance”