MX-3.com

That's great to see some more support. PLEASE send them an email. The link is in one of my replies at the top of this post. I advised them that they probably would not get a flood of emails, but rather more of a trickle. I also advised them that more people want them, but just won't take the time to email them. I WANT to see this header made.

I mailed them, everyone else needs to hop on the wagon and start mailing too

hurricane makes a header for both the dohc and sohc 1.6's. only 240 bucks too. corksport.com

Thanks for the info. It has been a long time since I was on Corksport.com. I cannot seem to find ANY information on this Hurricane company. It sounds like a crappy brand. Can you find a website or contact info for them?

hurricane doesn't have a web site, but i assume corksport can tell you all you need to know about them. they make decent headers for the v6, so the 4-cyl ones are probably good as well. plus CS told me that they were dyno testing them at hurricane for like 3 months before they were available for sale...

I have a custom-made header from a shop that makes them for race cars. I had the car back in 6 hours. <P>We traced the flange for the new header using the metal gasket. <P>The header has been with me for a year and a half.<P>It's not pretty and shiny, but it works. Dynos have nothing to do with it. Just look at the SOHC stock header and you will know that anything is an improvement compared to that.<P>I'll have it up for sale once my turbo is up and running.<P>In fact, I'll take a picture of it today and post it tomorrow.<P>See ya!

Gude Performance (Bull Frog) is making headers for the SOHC and should be ready for sale by feb. if all goes right.

I want one for my 1.6L DOHC
who do I email. thers soo much stuff in here its hard to read lol.

Mailed 'em.

Originally posted by RanMan:
A Muffler Shop CANNOT (or better yet....WILL NOT) take the time to research the engine and make several prototypes and then DYNO test to see which design is BEST for the engine. If I wanted any old **** header, I WOULD go to a muffler shop and have one fabricated (or fabricate one myself), but I want one that is powercoated, equal length, and "length-tuned" to the 1.6L DOHC engine. There is more to making a header than just bending tubes, welding it together, and making it bolt up to the head. I am sure that a header that was made after researching and DYNO testing would win in a so-called "Pepsi Challenge" with a header that was fabricated by a muffler shop.

not trying to pick an arguement but does a company like ss dyno their products or they just make shiny alternatives...?

i mailed 'em!!! we need all the help we can get! lol

Heck I e-mailed them like ten times...just kidding. I really hope this goes through..I dont care what they cost I will get them, granted they are dyno tested and fitted for the DOHC 1.6L

I just emailed them as well I would definately love a nice set in Chrome.

I just emailed them also.
It might help to spread this news to to some of the mx-3 news groups I imagin theres lots of people there who would be interested too.

did you guys happen to notice that this thread started in 2001?!

i doubt theyre still going to make them guys lol