Low RPM after intake install
Low RPM after intake install
Does anyone get this?<P>I installed a small 45 degree 3" pipe held by 2 silicone hose on both ends, then connected that to the afm and then to a k&n filter<BR>after drive until the car warms up, the rpm would drop to 500, sometimes even 100 (est guess of course), but it wouldn't stall. Heck, the car dosn't even feel like it's going to stall<P>is this normal?<BR>and what's the normal rate the mx3 should idle at?<P>thzanks<P>pizzamr2@hotmail.com
Re: Low RPM after intake install
I just have a Ractive filter on mine and my idle appears to be right around the 500 mark. What were you idling at before you did your install?<P>one
Re: Low RPM after intake install
Yes<P>Mine has always idled at 400-500 once warmed up, at least since I purchased it new in 93.<BR>it will occasionally dip down low when depressing the clutch pedal, but never stalls, and only for an instance.<BR>Andy P. 93 GS