Stainless steel clutch line from corksport anyone?!

[alberto95]

Has anyone bought the SS clutch line corksport sell for Mx-3? i ordered one, and when i try to install it, it doesnt fit after the hard line that comes after the slave, it too short!.. does anyone knows where it goes? pics? please help!

Alberto

[mx3TT]

I bought one a while back and it fit perfectin place of the rubber line. Its basically right under the battery.

[papa roached]

i got one, fits like a glove, almost like it was made for it

[torpedan]

Had no trouble with mine. I will try to get a picture if i dont forget about it.

[RoundTop]

I have one, what is the easiest way to install it? is there a howto or anything?

[alberto95]

Yeah, please post a how to guide or something! thanks!

[RoundTop]

Well, in the chiltons manual it says how to redo the entire system, including the line... but it doesn't say how to do it for just the line.

One thing is for sure, you will need some brake fluid and bleed the clutch after you install it.

[mx3TT]

Its simple. Get the fluid out of the lines. Disconnect the soft line by popping those little clips off and screwing them off the hard lines. Mine were rusted to the hard lines so it was a little tough to get off. Once you get the line one, put the clips back on and fill lines and bleed clutch.

[Macen]

Got one too. Fits like a glove. Easy to install. Remove battery and air intake. Then just loosen the two bolts. Remove the old brake line, and insert the new one. Took me half an hour, and I'm no mechanic.

[forcedairram]

I just installed one on mine, went on like a glove, 30 minutes including the bleeding.