Shift light install

4-Cyl. Technical/Performance Discussions
Post Reply
User avatar
BEERDDWR
Regular Member
Posts: 46
Joined: April 18th, 2003, 2:01 am
Location: SURREY B.C.

Shift light install

Post by BEERDDWR »

I just installed an auto meter shift light and wanted to confirm the wire I need to splice on the ecu to get the rpm signal. I think its pin b2 the dark green one on the largest plug but I’m not sure so if any one knows I’d really appreciate the help so I don’t blow it up.

thx
96 RS DOHC
75 shot zex kit
Ebay Intake and cat back exhaust
User avatar
Limegreen mx-3
Regular Member
Posts: 1778
Joined: October 29th, 2002, 2:01 am
Location: San Antonio TX
Contact:

Re: Shift light install

Post by Limegreen mx-3 »

I think the tach signal is the yellow/blue wire could be wrong can anybody confirm this laters

Drifter MX-3
(12.4@118@18psi) 92 MX-3, KIA (BP-DE)Swap, Electromotive TEC II Standalone, 8,200 Rev Limit, Custom Intake/Exhaust Manifold, 1,000cc PTE Injectors, Custom Fuel Rail, Aeromotive FPR, 80MM Holley TB, MSD 8.5MM Wires, NGK V-Power #8, SC6262 Turbo, 3 in. DownPipe, Tial WG/BOV, 600HP PTE FMIC, 2.5IN Intercooler Piping, EQUUS/Autometer KIA G-Series Tran, Extreme ACT Clutch, Built BP in starting process.
User avatar
BEERDDWR
Regular Member
Posts: 46
Joined: April 18th, 2003, 2:01 am
Location: SURREY B.C.

Re: Shift light install

Post by BEERDDWR »

Ya see I would have been wrong and i know the ecu would go pop and I would have to replace it.

Thx for the reply man.
96 RS DOHC
75 shot zex kit
Ebay Intake and cat back exhaust
User avatar
Typhoonk
Regular Member
Posts: 1138
Joined: December 31st, 2002, 2:01 am
Location: Bowmanville
Contact:

Re: Shift light install

Post by Typhoonk »

Tach -> Yellow/Blue at Distributor plug

probably the same wire at the ECU. But I would test it first
-------------------------------------------------------
Got to sell one of my cars to cover the bills
2002 Mazda Protege 5 - Manual, Blue colour fully loaded
PM for info
mxprecidia
Regular Member
Posts: 339
Joined: January 9th, 2004, 2:01 am
Location: Philly
Contact:

Re: Shift light install

Post by mxprecidia »

whered u get the light?
www.illegalCustoms.com
Tri-State Area Car Club
User avatar
BEERDDWR
Regular Member
Posts: 46
Joined: April 18th, 2003, 2:01 am
Location: SURREY B.C.

Re: Shift light install

Post by BEERDDWR »

ok so i tried tapping the wire @ the ecu and it didn't work????? :confused: .

I got it with a SportComp Auto meter moster tach at a garge sale in Terrace B.C.

Any other ideas would be greatly appreciated.
96 RS DOHC
75 shot zex kit
Ebay Intake and cat back exhaust
Post Reply

Return to “4-Cyl. Technical/Performance”