Air / Fuel Gauge

[zx6r]

hey guys,<P>Gonna hook up an air fuel gauge into my newly arrived gauge pod.. <P>Anyone done this before?? Need to know wires that should be run from oxygen sensor!<P>thanks<P>Tawheed

[jaydog5678]

Off the O2, black wire is signal, the other 2 white wires are ground and power. The black signal is where you need to tap into for the gauge to light up back and forth. Correct me if I'm wrong.

[OsoSlo z28]

you can tap the signal off those wires. i got the sig from the wire going into the ecu. i believe it's a red wire with a blue stripe. can't remember. check the online shop manual.

[marshmallow15]

old topic, but same subject. i have my autometer a/f gauge. have the ground hooked up and i know the other wires except for oxygen sensor.. do i just take the o2 sensor wire and splice it and get the signal from there? im pretty sure because the signal comes as an electric current so it'll be safe to splice it and solder the wires together again correct?

[Sonicxtacy02]

its easier to connect it at the ECU. The wire was black/blue (terminal 2D) for me but i'm a v6er

[xXx_OTEP_xXx]

i spliced the wire to the one from the throttle body ... if that made any sense

[marshmallow15]

hmm throttle body? don't you mean header?