weede`s KL-ZE Supercharger - Megasquirt

[mx3matt]

amazing job on the outlet, but i still think you should clearance the lower rad support.

[Thefez]

I absolutly love this car with a passion truly one of my favorite MX-3's on this site...

where did u get that piller with the pod?

[weede_klze]

Will that not contact during engine movement?

if will , i can take off some of material

BTW
i relocated power steering cooler (will be intercooler instead) and fit much bigger cooler from mazda 626

[weede_klze]

custom made water cooler (two times wider and 10cm less than stockk)


Intercooler on board


i want keep sleeper style

mooore coolers

[kulluminati777]

lol your power steering fluid gets that hot. I want to do the same but use it as an oil cooler. You said you got it from a 626? Or is it an aftermarket thing. did you cut the chassis any or it all fit behind the bumper just fine? Does look good BTW

[weede_klze]

no i dont want to cut chassie - only bumper was cut. Power steering cooler is OEM Mazda from 626 but i dont remeber witch one. Of course this power steering cooler is little exaggerated but why not

[Thefez]

any updates on this man?

[weede_klze]

unfortunately, the engine was broke One night two ZE retainer cracked and when my friend started to fix it I saw little marks on bearings causes of lack oil...So i now finish rebuild engine with KLDE valves/retainer (much stronger than ZE) and with reconfigurated oil relocation kit. I hope it will help, i lost this season

[posey92]

Love the supercharger...ill be doing the same but I have an M90 from the Ford Superbird. Havnt done the math yet. But im all about the budget. Ill figure out what ratio to get what psi I want then find some cam gears at the yard the size I need. Instant cog drive. No chamce of slipping.

[Nd4SpdSe]

M90 is pretty big...

[weede_klze]

M90 only in battery place

[Nd4SpdSe]

Even then, just for it's capacity, it's for a larger motor, 3.0 to 5.0L. My truck is a 3.3 with an M62

[weede_klze]

Car back on street

I have intaled KLDE retainers and springs.


Spring Set:)
- new gear selector
- OEM rubbers and screws for gear selector
- 10W60 Oil + OEM filter
- poli on the back
- SACHS cover for struds


Rear Tokico HP struds.

I thing i dont send this photo...Air filter for Supercharger

[kulluminati777]

YESSSS!!!!!!!! very cool i love its back on the road. What intake is that? I want to use a straight neck as well but im not 100% sure I want to relocated the battery just yet....

[Thefez]

would love to see some pics of the supercharger set up here how everythings installed