Front 5 lug upgrade

WhiteFinish · Post by **WhiteFinish** » September 15th, 2013, 11:49 am

Who can I make happy with some front 5 lugs ?

They came of a 323 v6, due that I only needed the spindle.

AaronTietje · Post by **AaronTietje** » September 15th, 2013, 12:26 pm

I would be super happy if I could get my hands on a rear 5lug setup.

WhiteFinish · Post by **WhiteFinish** » September 15th, 2013, 2:43 pm

That's also an option, but not as easy as you would think.

Probably getting the complete rear set, than disassemble and sending it.

AaronTietje · Post by **AaronTietje** » September 15th, 2013, 4:09 pm

I already have a 5lug front and would love to get the rear to match. Pm me a price on what the rear would cost.

Thanks.

MrMazda92 · Post by **MrMazda92** » September 16th, 2013, 3:23 am

Aaron, do as Scott D. and I have, 1st gen Probe parts.

You'll prefer that if/when you need to replace things.

Josh · Post by **Josh** » September 16th, 2013, 1:04 pm

Yeah what bearing does the 323 v6 use? are they the same as the MX?

marcdh · Post by **marcdh** » September 16th, 2013, 1:27 pm

Same up front which is handy. Rears are plug and play with just bearing/hub assembly and the discs.

Josh · Post by **Josh** » September 16th, 2013, 7:43 pm

Hmm, this may be what I am looking for then. Are the two bolt holes for the brake caliper further apart than the MX3 spindles? If so I am interested.

AaronTietje · Post by **AaronTietje** » September 16th, 2013, 11:07 pm

The only problem I have been having is I can't seem to find any probe rears

Except one guy on PT wanted to sell me a rear set for 450.

MrMazda92 · Post by **MrMazda92** » September 22nd, 2013, 5:17 am

The 2nd gen prove rears work if you reduce the profile of the rear TTL bushing, and cut the sleeve down. Also makes energy bushings a perfect fit.

WhiteFinish · Post by **WhiteFinish** » September 22nd, 2013, 1:54 pm

To make it clear, it's only the 5 lug.
You can switch this thing with your spindle + bearing

I do NOT sell the 323 spindle !

Josh · Post by **Josh** » September 23rd, 2013, 1:19 pm

WhiteFinish wrote:To make it clear, it's only the 5 lug.
You can switch this thing with your spindle + bearing

I do NOT sell the 323 spindle !

Well that makes sense now.

side question, do you know the spacing measurements between the caliper holes anyways

MrMazda92 · Post by **MrMazda92** » September 26th, 2013, 11:13 pm

Josh, measure the Probe parts. They're identical...

If you need the measurements, I can run a tape to where my car is parked and check...

MX-3.com