In need of and OIL PAN

[Whokid]

So my oil pan is now leaking and i called up mazda and they want $195, Partsource in canada wants only $99. The problem is they dont have a mx3 version but they do have a 96 for probe v6 one. Will that fit my car? Its either that or I go to the wreckers and pay$75 for used and said there will be rust on it. Need help on the probe oil pan

[johnmx3ze]

1- you need to write [WTB] before your tittle...
2- what engine do you have? 4cyl, v6?KL, K8?
3- where you from?

[johnmx3ze]

plus your not in the right section...

[Daninski]

Take your oil pan off, wash it with varsol (paint thinner) then soap and water then alcohol to finish the job. Buy a two part epoxy and after sand blasting (cleaning all the rust off somehow) apply the epoxy. Give it two coats on the outside. You can use a heat lamp or a trouble light to warm the pan and that will assist in the curing. Reinstall the pan. You can actually form some steel over the holes if its a flat section and place that over the wet epoxy then after curing, epoxy over the steel patch as well.