If you have any idea what he's doing then it may work. The LED can work, I believe, even if the CEL doesn't work. I think there's a procedure for which pins to jump for the LED.
Probably time to start searching the forums at this point...
Obd 1 or 2
-
DeepBlueMX3
- Regular Member
- Posts: 373
- Joined: September 13th, 2008, 9:02 pm
- Location: City:Americana Country:Brazil
- Contact:
Re: Obd 1 or 2
Ok man, at this point, I just know the the error codes(paperclip 4cyl faq, thanks), and the conections for the LED and Jumper,umcamara wrote:If you have any idea what he's doing then it may work. The LED can work, I believe, even if the CEL doesn't work. I think there's a procedure for which pins to jump for the LED.
Probably time to start searching the forums at this point...
LED ===> negative(FEN), positive(B+)
Jumper==> TEN and GND
Tomorow I'll test then!
Thanks !
-
DeepBlueMX3
- Regular Member
- Posts: 373
- Joined: September 13th, 2008, 9:02 pm
- Location: City:Americana Country:Brazil
- Contact:
Re: Obd 1 or 2
The LED works fine, like in the youtube video!
Thanks to Ryan and Umcamara !
Thanks to Ryan and Umcamara !
Re: Obd 1 or 2
Is it still 2 oxygen sensors for the obd1 mx3
-
DeepBlueMX3
- Regular Member
- Posts: 373
- Joined: September 13th, 2008, 9:02 pm
- Location: City:Americana Country:Brazil
- Contact:
Re: Obd 1 or 2
I only know about one sensor, called "lambda".ramsen25 wrote:Is it still 2 oxygen sensors for the obd1 mx3