engine mounts
engine mounts
anyone know where i can buy performance mounts something better then factory
Re: engine mounts
AWR motor mounts
AwrRacing.com
AwrRacing.com
92, Gs-Ze. KL31 motor/curve neck IM, Cai,Chipped ecu,awr mounts,clutchmasters stage 2 "R",
Se interior,Wrap around spoiler, oem full sides and MS front bumper
Se interior,Wrap around spoiler, oem full sides and MS front bumper
Re: engine mounts
i take it i would use the mx6 mounts cuz there no mx3
Re: engine mounts
look harder lol..... sheesh people are lazy and dont wana bother looking further than 6 inches in front of their face...
i just clicked on the site, went to products and pulled up the mounts lol........
http://www.awrracing.com/store/index.php?cPath=107" onclick="window.open(this.href);return false;
probe front/mx3 rear is what i went with. 88D' for now getting the 95's later on.
i just clicked on the site, went to products and pulled up the mounts lol........
http://www.awrracing.com/store/index.php?cPath=107" onclick="window.open(this.href);return false;
probe front/mx3 rear is what i went with. 88D' for now getting the 95's later on.
92, Gs-Ze. KL31 motor/curve neck IM, Cai,Chipped ecu,awr mounts,clutchmasters stage 2 "R",
Se interior,Wrap around spoiler, oem full sides and MS front bumper
Se interior,Wrap around spoiler, oem full sides and MS front bumper
- solo_ryder
- Senior Member
- Posts: 6289
- Joined: October 16th, 2004, 2:01 am
- Location: British Columbia
Re: engine mounts
They are there ramsen. As Greg said, probe front mx3 rear. 88a is good streetable durometer
Re: engine mounts
ahaahahahahaha man im serious i didnt see them
Re: engine mounts
Just curious why you'd get the probe front mount? Looks the same as the MX-3 one in the pictures.
1992 Mazda MX-3 GS KLZE
- marcdh
- Regular Member
- Posts: 1460
- Joined: July 26th, 2006, 3:54 pm
- Location: Belfast -Northern Ireland
- Contact:
Re: engine mounts
Ironically better fitment, unless they revised the mx3 front design.
Thread explaining it
Thread explaining it
Get the probe front and you just widen your xmember holes by a few mm, 2mins with a drill, easy!solo_ryder wrote: The reason why I and others say use the probe front is because awr obtained a front mount from mazda to make their mount for the mx3. For some reason they received and replicated a mount that is too skinny. My buddy has a mx3 mount and he has to run about 6 washers on each sidev of the mount to make it fit snug. Not a big deal, but the probe one does fit better.
AZ-3 1498cc Turbo! EVO 8 turbo and manifold, 5 stud swap, SSR Type C, DIYPNP seq Megasquirt
Mx-3 2.5 V6 Turbo 291 BHP 251 lbft @ 8psi - Retired due to rust and back at uni
View Worklog
Mx-3 2.5 V6 Turbo 291 BHP 251 lbft @ 8psi - Retired due to rust and back at uni
View Worklog