FS : CT - 1992 WHITE GS WITH 2.5ltr

[wkdmx3gsr]

I have a 1992 Mazda MX-3 GS 5-SPEED with a 2.5ltr v-6 motor. 3,500.00 neg.

ALL NEW PARTS ARE AS FOLLOWS: NEW CLUTCH, LIGHTWEIGHT FLYWHEEL, LIGHTWEIGHT CRANK PULLEY, WATER PUMP, PWR STEERING PUMP,

ANGEL EYED PROJECTOR HEADLIGHTS, SMOKED TAILLIGHTS, SHORT SHIFTER, JDM STEERING WHEEL WITH SHORT HUB ADAPTOR,

NEW CUSTOM MAGNAFLOW DUAL EXIT EXHAUST SYSTEM FULL 3" FROM THE HEADERS, DIAMOND AUDIO COMPONENT SPEAKERS IN THE

FRONT AND REAR, CROSSFIRE AMP, NEW BATTERY, DIGITAL BATTERY TERMINALS, THERMOSTAT, DRIVE BELTS, PWR WINDOWS,

PWR DOOR LOCKS, 2 OTHER INTAKE MANIFOLDS ONE DRILLED AND TAPPED FOR DIRECT PORT NITROUS. NITROUS KIT AVAIL AS WELL.

HAS CARBON FIBER DASH BEZEL, REVERSE GLOW DASH LIGHTS NOT YET INSTALLED, ALONG WITH PUSH BUTTON START AS WELL NOT YET

INSTALLED. NEW REAR BUMPER AND ALSO HAVE SIDESKIRTS TO GO WITH AS WELL. CAR RUNS GOOD AND SOUNDS MEAN.

I HAVE TONS OF EXTRA PARTS AND STUFF LAYING AROUND FOR THIS CAR ALL WILL GO WITH IT IF YOU WANT IT

[wkdmx3gsr]

[onlytrueromeo]

That's a K8 Intake Manifold, so either you're lying or you're not taking advantage of the 2.5L by restricting its power.

[mx3autozam]

Going by the messy plug wires and the labled vacumn lines in the pic the motor has probably been pulled. Alot of people run the k8 manifold for the ease of installation.

[mx3autozam]

Who owns the Evo?

[wkdmx3gsr]

That's a K8 Intake Manifold, so either you're lying or you're not taking advantage of the 2.5L by restricting its power.

wow people are quick to call other LIARS on here... Its been swapped to a 2.5 probe moter as stated. No crap it is a 1.8ltr manifold i have the MS8 manifold as well as the straight necked probe one too. all manifolds go with the car along with all other parts in my 3rd garage.

[wkdmx3gsr]

Going by the messy plug wires and the labled vacumn lines in the pic the motor has probably been pulled. Alot of people run the k8 manifold for the ease of installation.

Thanks and its the wifes new 2008 EVO X GSR.