disributor o ring leak
-
- Regular Member
- Posts: 274
- Joined: September 14th, 2006, 2:34 pm
disributor o ring leak
hey everyone, well ive been installing a turbo on my car and hope to take it for a little cruise tomorrow or this weekend. on my last distributor when it went it was smking out of the disti and oil was in there. so i got a replacement disti and i think its still leaking... do i just get a new o ring for the disti or new rocker cover gasket to? and the two bolts that hold down the cap that the disti slides into, do they have to be torqued to a specific ft.lb ? if so what?
dohc b6, intake, exhaust, miata cams ready to go in
Re: disributor o ring leak
Your disty o-ring is likely old and hard. Get a new one from
a parts store or from rockauto.com they are under a buck.
Torque till tight.
a parts store or from rockauto.com they are under a buck.
Torque till tight.
1994 MX-3 RS
Worklog: viewtopic.php?f=46&t=62251
B6 goodies for sale:
viewtopic.php?f=2&t=66333
2nd BP engine: http://www.clubprotege.com/forum/showthread.php?t=46695