Rubber Seals for Doors, Windows, Everything!!
Rubber Seals for Doors, Windows, Everything!!
I've been looking to replace all of my rubber seals but I have one slight draw back, I can't find any new sets! Does anyone know where I could find some?
For your much needed part # and $ I present for your viewing pleasure!
Windshield Molding Top E06T-50-60B1 $10.25
Windshield Molding Bottom E040-50-601B $112.27 Seems high I'll call and recheck!
Windshield Molding Sides GA2A-50-60B2 $8.63
Door Seal Left EA01-50-650C $111.38
Door Seal Right EA01-50-640C $111.38
Door Weatherstrip Left EA01-59-760D $84.40
Door Weatherstrip Right EA01-58-760D $84.40
Window Runner Left DA01-68-912B-02 $49.51
Window Runner Right DA01-68-911B-02 $49.51
Hatch Seal Upper EA01-50-611D $51.47
Hatch Seal Lower EA01-50-612D $29.46
Hatch Weatherstrip EA01-62-761C $122.78
This is Based off of him pulling my vin#
This is also the quote from the parts dept. from Gene Messer Mazda of Amarillo, TX in U.S. prices.
For your much needed part # and $ I present for your viewing pleasure!
Windshield Molding Top E06T-50-60B1 $10.25
Windshield Molding Bottom E040-50-601B $112.27 Seems high I'll call and recheck!
Windshield Molding Sides GA2A-50-60B2 $8.63
Door Seal Left EA01-50-650C $111.38
Door Seal Right EA01-50-640C $111.38
Door Weatherstrip Left EA01-59-760D $84.40
Door Weatherstrip Right EA01-58-760D $84.40
Window Runner Left DA01-68-912B-02 $49.51
Window Runner Right DA01-68-911B-02 $49.51
Hatch Seal Upper EA01-50-611D $51.47
Hatch Seal Lower EA01-50-612D $29.46
Hatch Weatherstrip EA01-62-761C $122.78
This is Based off of him pulling my vin#
This is also the quote from the parts dept. from Gene Messer Mazda of Amarillo, TX in U.S. prices.
Last edited by ionic1000 on April 27th, 2009, 9:06 pm, edited 1 time in total.
Re: Rubber Seals for Doors, Windows, Everything!!
Try a Dealer, those are parts I've never seen the benefit in gettin used. I've done some under the hood, both doors (huge improvement) and I think I might have done that hatch... I'll hafta check on that one. If it's rubber it's worth replacing on a 17 year old car
Re: Rubber Seals for Doors, Windows, Everything!!
I was afraid I was going to have to pay dealer prices!
- Mooneggs
- Forum Moderator
- Posts: 6128
- Joined: August 10th, 2005, 10:08 pm
- antispam: ~SPAM*SUX~
- Location: Hillsboro, OR
- Contact:
Re: Rubber Seals for Doors, Windows, Everything!!
the only thing I could suggest other than a dealer is go to junkyards and maybe you will get lucky... or look for someone parting out their car... but like jutzi said, rubber is kind of pointless to buy used unless yours is REALLY destroyed...
good luck
good luck
My Feedback
92 mx-3 gs klze 'race car' IP 15.05 @ 92.5mph
92 mx-3 gs klze 'daily driver' IP 14.55 @ 95.7mph
http://www.cardomain.com/id/Mooneggs
92 mx-3 gs klze 'race car' IP 15.05 @ 92.5mph
92 mx-3 gs klze 'daily driver' IP 14.55 @ 95.7mph
http://www.cardomain.com/id/Mooneggs
Re: Rubber Seals for Doors, Windows, Everything!!
Thanks for the info even though it was definitely not what I wanted to hear. (I just feel dealers rip you off!) Well I guess I just have to bite the bullet now.
Re: Rubber Seals for Doors, Windows, Everything!!
Good to see another Texas MX-3 in the house! I'm in the same boat as you man, I'm going to have to go to the Mazda dealership and ask them as well. I'm reluctant to do so, though, cause my car is so unbearably ugly. The outside is...unpleasant. The interior is near perfect though. The cracking seals on the windshield, hatch, and doors don't help the already fading, chipping, and mismatched paint. I'm getting it there, slowly.
Hey-yo chicken on a raft.
Re: Rubber Seals for Doors, Windows, Everything!!
Yup, stealerships, crooks, synonymous.
1993 Blaze Red SE, 17" blackie's, b+m sts, 45 deg 3" exh pipe/intake tube, K8ZE, aftmkt probe headers, magnaflow hi-cat, all 2.5" piping, magnaflow muffler.
1976 Datsun 620 p/u, full airride, Firestone 2600`s, 16ga fuel cell, Optima yellow top, AZ compressor, custom tubular frame with 9in step notch, 18" 100 spokes
1955 Willys Overland 4x4 P/U, '78 LT1 350 cu.in, fully restored.
Re: Rubber Seals for Doors, Windows, Everything!!
Hey Thassodar where are you located at? I'm about 45 minutes north of Amarillo. I got the same problem, the old Texas heat has not been kind to my MX. Not to mention the previous owner's wrath!
Re: Rubber Seals for Doors, Windows, Everything!!
i can give u one tip.. cause i just went through this ... the litle plastic clips that hold on the stripping around the whole door ..are 150 ish each... so try keep the clips.. u can get them out from inside the door if u take off the skin and s---.. good luck
Re: Rubber Seals for Doors, Windows, Everything!!
150 for a clip Someone is getting fat off that! Do they offer any lube while there at it! Thanks for the heads up!
- onlytrueromeo
- Senior Member
- Posts: 2756
- Joined: May 16th, 2007, 10:05 pm
- Location: Albany, NY
Re: Rubber Seals for Doors, Windows, Everything!!
I think he meant 1.50, lol if they were $150 each for a piece of plastic that small, you'd have to be mentally incapacitated to buy them...you need like 20 clips for the door, so who would pay 3000 for that hahaha.
Re: Rubber Seals for Doors, Windows, Everything!!
Ya I was needing to check my britches after that! $1.50 is a lot more reasonable in comparison!
Re: Rubber Seals for Doors, Windows, Everything!!
Yes I'm slow before anyone asks!
Re: Rubber Seals for Doors, Windows, Everything!!
I looked up your town and you're WAAAAY far from me. I'm in Arlington, about 10-15 miles west of Dallas. Let me know how much they tell you for the whole kit so I can ration my money aside.
Hey-yo chicken on a raft.
- onlytrueromeo
- Senior Member
- Posts: 2756
- Joined: May 16th, 2007, 10:05 pm
- Location: Albany, NY
Re: Rubber Seals for Doors, Windows, Everything!!
Im interested in this info as well!