Help Needed
Help Needed
I just got my 92 4c Mx-3 and started tuning it up change da timing,pump,plugs,wires,pick up my new cap and rotor and gas filter. but wondering if this will stop the rough idling it has been doing lik shakes like hell inside when in p and N also misses so wat else should i do to fix this???
Thanks 4 ur help
DonZ
Thanks 4 ur help
DonZ
Re: Help Needed
check your wires make sure you have them in correct firing order
Re: Help Needed
if you are getting a lot of shaking at idle I think one of your motor mounts might be bad.n Not sure though
Re: Help Needed
Also a vacuum leak could be the cause.
<a href="http://www.fodey.com/generators/animate ... .asp"><img src="http://r3.fodey.com/117ef9486659942269d ... 7601.1.gif" border=0 width="404" height="110" alt="Ninja!"></a>
Re: Help Needed
That alot guyz means alot... wats to fix a vacuum leak noob question i know
- Ryan
- Senior Member
- Posts: 7198
- Joined: April 7th, 2008, 1:06 pm
- antispam: ~SPAM*SUX~
- Location: Manitoba
Re: Help Needed
When air leaks into the engine AFTER the VAF (little box or cylnder in your intake) has 'measured' it.
Lets say you took the intake right off right at the throttle body. You gunned it, and the engine sucks in all the air it wants, and the VAF will read minimal airflow (because its not even atatched, the engine isn't sucking the air through it) So the ECU will be telling the injectors to give the right about of gas and distributor spark at the time that would be needed for idle, meanwhile the engine is trying to run at 6K, the car still thinks its at idle (not really, because it has other speed sensors) The point is it gets confused because the engine is going faster, but as far as it can tell, not taking any air, so maybe the car figures you're downshifting? Either way its all confused and it will run rough.
So, a vaccuum leak means that unaccounted for air is getting into the engine, wrecking the measurements that the car needs to run nicely.
Or even better, its leaking after the throttle body. Now the engine has no idea whats going on, the throttle is closed, no air is coming through the VAF, but the engine is surging? Once again it runs rough, trying to correct the problem.
Lets say you took the intake right off right at the throttle body. You gunned it, and the engine sucks in all the air it wants, and the VAF will read minimal airflow (because its not even atatched, the engine isn't sucking the air through it) So the ECU will be telling the injectors to give the right about of gas and distributor spark at the time that would be needed for idle, meanwhile the engine is trying to run at 6K, the car still thinks its at idle (not really, because it has other speed sensors) The point is it gets confused because the engine is going faster, but as far as it can tell, not taking any air, so maybe the car figures you're downshifting? Either way its all confused and it will run rough.
So, a vaccuum leak means that unaccounted for air is getting into the engine, wrecking the measurements that the car needs to run nicely.
Or even better, its leaking after the throttle body. Now the engine has no idea whats going on, the throttle is closed, no air is coming through the VAF, but the engine is surging? Once again it runs rough, trying to correct the problem.
Now with Moderator power!
Black '93 BP RS - wrecked, parted, scrapped.
Green GS - Sold.
Black GS - Summer DD/Race car - Fancy KLZE
Red GS - K8-ATX -> MTX-KLDE - Frakencar. Scrapped
White GS - Rusty. Parts. Scrapped
1997 BMW M3 - my summer baby
2002 BMW 325Xi - sold
2003 Forester Xti - EJ20K swapped.
Feedback
Black '93 BP RS - wrecked, parted, scrapped.
Green GS - Sold.
Black GS - Summer DD/Race car - Fancy KLZE
Red GS - K8-ATX -> MTX-KLDE - Frakencar. Scrapped
White GS - Rusty. Parts. Scrapped
1997 BMW M3 - my summer baby
2002 BMW 325Xi - sold
2003 Forester Xti - EJ20K swapped.
Feedback
Re: Help Needed
cool thanks alot man ima get this done in no time unrelated question is everyne from the states on this page
Re: Help Needed
nope
- Savin
- Regular Member
- Posts: 1580
- Joined: November 18th, 2007, 3:05 pm
- Location: Crown Point, IN (Chicago area)
- Contact:
Re: Help Needed
Most people on here tend to be from Canader. It seems about 50/50 though.
'95 MX-3 RS - Project "Déjà Vu" Destined for the scrapyard.
'93 MX-3 GS - SOLD!
'93 MX-3 GS SE - Parts car!
'94 MX-3 GS - Scrapped
'94 MX-3 RS - Scrapped
'96 Sunfire SE - Scrapped
'03 Sunfire SE - Deathtrap
'95 Cavalier Base - Scrapped
'94 Thunderbird LX - Collects dust
'89 Mustang GT - SOLD!
'93 MX-3 GS - SOLD!
'93 MX-3 GS SE - Parts car!
'94 MX-3 GS - Scrapped
'94 MX-3 RS - Scrapped
'96 Sunfire SE - Scrapped
'03 Sunfire SE - Deathtrap
'95 Cavalier Base - Scrapped
'94 Thunderbird LX - Collects dust
'89 Mustang GT - SOLD!
Re: Help Needed
look, below the person's name, most people have where they live. I live in the US near Knoxville.