![Image](http://i285.photobucket.com/albums/ll46/npspears/TDRebaypistons.jpg)
Is it possible to tell if pistons are good quality just by a picture? I doubt it, but doesn't hurt to ask. Not sure what that blue spec is all about. What do you guys think of these pistons?
Yeah I understadn that, but I'm thinking that carbon is going to build up fast on the rough casting surface in the valve relief area. I would have though that factory pistons would have the valve reliefs machined.se7en wrote:When I say cast, I mean 'NOT FORGED'.
all pistons are machined on the sides, and top.
and some on the bottom too
as well as the wrist pin bore.
I hope that helps.
7