Ford Probe turbo kit fit on MX3? (PICS)

[se7en]

well, some will say that the turbo from the ebay kit is no good, but I have had good luck so far.

7

[Mooneggs]

well, some will say that the turbo from the ebay kit is no good, but I have had good luck so far.

7

heheh I'll give it another 1000 miles

[se7en]

ya, I here ya, but I got a t4 60-1 turbo to replace it when it goes

turbonetics one, so I will be fine then

7

ps, I have got 12 tanks of gas out of this one already and have had no problems

I am the luckiest ebay turbo guy so far.

[Open_dump]

those ebay turbo pipes bolt right up with no clearance issues? i wanna buy a set right now but im trying to find out if i need a shop to cut and make em fit.

[se7en]

well, the actual pipes fit just fine. but when you put the cross member back on, you will be in for a surprise.

the front to back crossmember will have to be cut and welded to allow clearance for the up-pipe.

other than that, they fit great.

oh yeah, have fun with the rear enhaust manifold. it is a b----.

7

[Open_dump]

ive always known about the modded crossmember....i thought there was some other clearance issues.....why was the exhaust a b----? messin with the bolts and such? i can imagine....ps. thanks for the info se7en

[se7en]

the exhaust is a pain because the probe is a little longer than our mx-3's so the exhaust bolts up a bit farther.

so on our cars, you have to cut some of your stock exhaust and reweld it to the pipes.

most just go to the muffler shop. It would cost roughly $50.

cheers.

7

[9Red3]

I suppose this wouldn't be a great first project to attempt if i have little experience with engines and such eh? I'd love to turbo my car, faster is always better!

[se7en]

well.....it depends on how much money you have

7