engine stand

cstott282 · Post by **cstott282** » July 2nd, 2007, 3:27 pm

hey my friend just bought an engine stand and we are going to put my DE on it to replace all the gaskets in it but i need to know what the correct size bolts that are needed are... could somoene help me out please

1992blazeredgs · Post by **1992blazeredgs** » July 2nd, 2007, 3:36 pm

i ran into that same problem, the bolt size should be 12 x 1.25 x 100mm. I also had problems getting all four fingers to fit on the block. I ended up only using three and than wedged a peice of wood underneath when i wasnt working on the motor to relieve some of the stress.

Nate