the codes your pulling you cant really hold to much "truth" to what they are saying simply because the motor hasnt ran yet, if they are pulling codes, it might be because they are not hooked up or the solenoids themself are bad.cerian_ca wrote:I no nobody who owns an mx.
Anyway, I charged the battery for the whole night and my CEL resurect
I got my codes too
5 knock sensor (but I cleared, and it's gone)
9 coolant temperature sensor (it's broken since yesterday)
25 fuel pressure regulator control solenoid
41 vris 1
46 vris 2
i don't know what's wrong with the vris, and I don't know where is the fuel pressure regulator control solenoid.
are you sure your getting fuel, maybe you have your fuel lines backwards,
fuel pressure regulator control solenoid is the solenoid that goes from the intake and controls the fpr, k8s and kldes use them, ze dont.
code 9 just pull your old sensor off your k8, it will work (if you have it)
if you cleared the knock sensor code then dont worry about it unless it comes back (could very well be why it wont start up)
If you never checked the compression per cyl you should go ahead and do that now, just to make sure its not an internal issue, plus this is something you sorta wanted to check before you even installed the motor. just to be sure the motor was good.