Diagnosis -plug pinout? (CEL)

Jeppert · Post by **Jeppert** » April 19th, 2007, 3:33 pm

Hi guys,

I recently bought an MX-3 for the missus, and am currently trying to sort out the typical "rough idle" -problem. I have done searches on the forum and read the technical manual and all, and figured the best way to go would be to start with the diagnostic codes. I printed out this: http://www.atlantamx3.com/mocaforum/vie ... 06658ea03b and headed out to my garage.

I did locate the diagnostic plug, but I can not figure out which pin would be the "TEN" and which the "GND". The car is with the B6-engine (1.6i DOHC). Please could anyone point me towards the right direction?

ariesdude · Post by **ariesdude** » April 19th, 2007, 4:40 pm

The pinout should be printed on the diagnostic box cap (inside)...

Jeppert · Post by **Jeppert** » April 19th, 2007, 4:45 pm

Thanks for the reply. Sorry, I forgot to mention that I ofcourse checked that first as it would've been obvious that it would be there. But it isn't, so some further suggestions would be welcome?

ariesdude · Post by **ariesdude** » April 19th, 2007, 4:54 pm

Jeppert · Post by **Jeppert** » April 20th, 2007, 2:46 am

Thanks!