do 93 Mx-3 have cupholders???

General Mazda MX-3 Discussions
rockfordgirl
Junior Member
Posts: 14
Joined: January 4th, 2007, 11:41 pm
Location: Peterborough, Ontario

do 93 Mx-3 have cupholders???

Post by rockfordgirl »

Ive have 2 93 MX-3 GS and both of them have ashtrays.... ive been looking in wreckers EVERYWHERE for cupholders and i cant find them anywhere :( can someone help me out! i dont smoke and i have no use for an ashtray lol
:D
alreadydefective
Regular Member
Posts: 49
Joined: October 27th, 2006, 2:26 am
Location: Omaha

Post by alreadydefective »

as far as i know, it doesnt, i have a 93gs also, and dont have one so *shrug*, i wish i had one though, i just used my ebrake to hold a bottle still though, its a neat little trick i picked up :-)
User avatar
TREVO123
Regular Member
Posts: 654
Joined: November 29th, 2005, 8:57 pm
Location: BC, CANADA
Contact:

Post by TREVO123 »

alreadydefective wrote:as far as i know, it doesnt, i have a 93gs also, and dont have one so *shrug*, i wish i had one though, i just used my ebrake to hold a bottle still though, its a neat little trick i picked up :-)
Same hahaha works good with a double gulp slurpee
TREVO-Under major construction, Bp coming soon! TO a mx3 near you
1993 MX-3 RS,FULL BLITZ KIT(PROTOTYPE)17"10 SPOKE RIMS,SOHC 1.6L.
http://www.cardomain.com/ride/2189811
alreadydefective
Regular Member
Posts: 49
Joined: October 27th, 2006, 2:26 am
Location: Omaha

Post by alreadydefective »

heck yes, hah
rockfordgirl
Junior Member
Posts: 14
Joined: January 4th, 2007, 11:41 pm
Location: Peterborough, Ontario

Post by rockfordgirl »

I usually stick cans of pop between the side of the seat and the door.. i find that works too! but then i forget its there :( lol crap! i found cupholders for a 94 but theres no way im tearing apart my whole dash just for cupholders :evil:
User avatar
Tunes67
Supporting Member
Posts: 4708
Joined: January 27th, 2005, 6:36 pm
Location: Everett, WA
Contact:

Post by Tunes67 »

You should have a cupholder inside your centercolumn glove box.. flip open the top and there should be a fold down cup holder. Its just a single and wont hold anything bigger than a pop can or bottle.. maybe a latte if your into that stuff. But I suppose its better than nothing.

Tunes67
"So long.. and thanks for all the fish!" "Momma says VW Bugs are the devil" "This one time at band camp.. I stuck a flute in my Throttle Body" ;)
"Screw you guys.. I am goin home"

I am the Cranky God of Mods!!! Tremble before my fury!! LOL
User avatar
Custommx3
Site Administrator
Posts: 8391
Joined: November 7th, 2000, 2:01 am
antispam: ~SPAM*SUX~
Location: Lat 35.1N Lon -90W
Contact:

Post by Custommx3 »

Some came with an insert that sits in your center console to hold them. I had one, but I threw it away cause my console was broken.

This has nothing to do with V6 Technical, moved to General.
User avatar
neutral
Supporting Member
Posts: 1770
Joined: December 27th, 2004, 10:19 am
Location: U.S. Mid Atlantic

Re: do 93 Mx-3 have cupholders???

Post by neutral »

rockfordgirl wrote:Ive have 2 93 MX-3 GS and both of them have ashtrays.... ive been looking in wreckers EVERYWHERE for cupholders and i cant find them anywhere :( can someone help me out! i dont smoke and i have no use for an ashtray lol
:D
Hey, PM me your address and I'll ship ya a carton of cigs. :wink: and...
Welcome to the board.
Image -Jim
User avatar
atlantamx3
Supporting Member
Posts: 2888
Joined: June 2nd, 2001, 2:01 am
Location: Kennesaw, Ga, USA
Contact:

Post by atlantamx3 »

Like Tunes Said, there is one dinky metal ring that flips down inside the lid of your center console. It wont really hold anything though, or keep it upright if you have to stop quickly! LOL
~Perry
Please visit
http://www.mx3-atlanta.com
Image
User avatar
Nd4SpdSe
Senior Member
Posts: 11212
Joined: May 25th, 2002, 2:01 am
Location: Québec City, Quebec, Canada
Contact:

Post by Nd4SpdSe »

Well, you can also get the double-deck center console. that has a 2 cup holder on the lid, 4 is you use and get the insert.

As well, there's alternative. You can get "JDM" din cupholders on eBay once in a while
http://cgi.ebay.com/ebaymotors/Console- ... enameZWD1V

Or get a din cup holder w/change tray from a Ford Taurus, I used that for a bit too..
Last edited by Nd4SpdSe on February 6th, 2007, 8:36 pm, edited 1 time in total.
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
bubsy83
Regular Member
Posts: 106
Joined: November 2nd, 2006, 3:08 pm
Location: Stratford

93 MX-3

Post by bubsy83 »

I didn't know about the console, I am going to check that out. So far I thought I was outta luck and just put a crappy tire cup holder in the front air vent until I could come up with something better in appearance and function...thanks :D
User avatar
Nd4SpdSe
Senior Member
Posts: 11212
Joined: May 25th, 2002, 2:01 am
Location: Québec City, Quebec, Canada
Contact:

Post by Nd4SpdSe »

np ;)

Oh, i forgot to post a pic of the double-deck center console/armrest

I have one, although I dont have pics of it really in action
Image

There's also one that just ended on ebay, but i'll give you a good idea on what yo look for.
http://cgi.ebay.com/ebaymotors/MAZDA-MX ... 7648QQrdZ1

One think I wanted to try is to fit the 94+ dash cupholders into the 92-93 dash. I have the cupholders. I just need to figure out/find out if it's fesable/doable, especially, i'd be sacrificing my cig lighter outlet, which I use to chage my cell phone
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
User avatar
mitmaks
Senior Member
Posts: 8704
Joined: September 10th, 2001, 2:01 am
antispam: ~SPAM*SUX~
Location: Spokane, WA
Contact:

Post by mitmaks »

my se came with cupholders
Magnum s/s lines, strut bars, carbon fiber bezel, indiglow gauge, Sony Xplod, inverted c/f hood, SRD lower tie bar '93 GS SE '95 Cobra SVT #2722 '68 Charger R/T 440
http://www.cardomain.com/id/mitmaks
Image
User avatar
atlantamx3
Supporting Member
Posts: 2888
Joined: June 2nd, 2001, 2:01 am
Location: Kennesaw, Ga, USA
Contact:

Post by atlantamx3 »

mitmaks wrote:my se came with cupholders
Stop rubbing it in!

:P
~Perry
Please visit
http://www.mx3-atlanta.com
Image
User avatar
Nd4SpdSe
Senior Member
Posts: 11212
Joined: May 25th, 2002, 2:01 am
Location: Québec City, Quebec, Canada
Contact:

Post by Nd4SpdSe »

Well, I got them for my non-SE, so :P

Not all SE's had the, if it was even an SE only option. I know MX3autozam's SE didn't some with them....
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
Post Reply

Return to “General Mazda MX-3”